NEWS

The company successfully obtained the evaluation results of the integration of information technology and industrializationOn December 5, 2022, The integration of industrialization and industrialization declared by the company, after passing the on-site audit, rectification of non-conformance, asses

Last week, the production technology department of Guangzhou sailong polished the tantalum irregular parts. The size of this part is about 18mm long, 16mm wide and 1.8mm thick Mobius ring shape jewelry pieces. The polishing technology requirements are relatively high when the surface reaches the bri

On October 19, 2022, the production technology department of Guangzhou Sailong carried out the printing of titanium long dragon crafts. According to the printing requirements of the model, the original 150*150mm forming area could not meet the placement of parts.Therefore, the forming area of this p

Guangzhou Sailong cooperated with the First Affiliated Hospital of Army Medical University.The surgery was performed by Professor Chen Guangxing, Deputy director of the Department of Joint Surgery, and Professor Wang Fuyou led the 3D model design. The personalized DDH acetabular tantalum pad was pre

The Logistics Support Department this week carried out the preparation of hafnium powder, a total of 2 hafnium rods, a total of 1.77kg, the preparation of hafnium powder 1.16kg, after screening and storage. Among them, the particle size of 50-150μm has 1.1kg, the yield of 65.54%, the particle size o

Co-Cr-Mo (CCM) alloy is a kind of alloy commonly used in orthopedic implants. It doesn’t contain Ni element which can cause allergy or even cancer. It has high strength, superior corrosion resistance, non-magnetic property and excellent biocompatibility. E-beam 3D printing plays an important role in